Screws, nuts & small parts for Aprilia RX 125

Clutch cable adjusting screw, M8, universal

Dimensions: Thread: M8 Inner diameter: 8.5 mm

Available

€2.99 *

Simple exhaust spring, to hang the exhaust system on the cylinder, or to connect the muffler & manifold. Can also be used for other tinkering. The spring has ring eyelets at both ends. A little trickier to fit, but the hold is better!...

Available

€2.59 *

Screw, M6 x 20 mm, flat head / inner corner (Torx), stepped

Typical brake disks, or sprocket bolt with blue dry thread lock (medium strength). Can also be used anywhere else on the moped. Thread: M6 Head: Flat / Torx Length: 20 mm

Available

€1.99 *

Cover cap brake bleeding nipple, different colours, pack of 2

During maintenance work on the brake system, these small parts are often lost. The bleeder nipple can then become clogged and maintenance of the brake system becomes impossible the next time. A cover should therefore always be installed!

Available

€2.99 *

Wheel bearing, different vehicles, type: 62012RS

Wheel bearing which can be used for different vehicles as front or rear wheel bearing. Note Please compare the technical data of this bearing with your original wheel bearing. Technical data Outside diameter: 32 mm width: 10 mm Inner...

Available

€5.99 *

Ball bearing 6202 2RS, universal

Universal SKF bearing of type "6202-2RS", sealed on both sides. Suitable for example as rear or front axle bearing. But please compare your bearing type before ordering! Technical data Type : 6202 Inner diameter : 15 mm Outside diameter...

Available

€6.29 *

Oil drain plug, universal, M12x1.5, magnetisch

Magnetic oil drain plugs collect the metallic abrasion at the magnet and thus protect the engine & gearbox from excessive wear. Supplied with sealing ring.

Available

€5.99 *

Cylinder head nut, Set of 4 - M7

Nut with M7 thread for fixing the cylinder head. A set of 4 special nuts is supplied. The nuts have a length of 13mm and have a collar. Special thread M7. Suitable for all Minarelli, Kymco, MBK, Yamaha, CPI, Keeway engines and other...

Available

€3.99 *

Clamp, universal, for example f. petrol, water or oil hoses, 6mm

6mm clamp for fuel hoses. Delivered is 1 piece.

Available

€1.99 *

Retaining clamps set, e.g. for cladding

We can supply these spare clips for your fairing at a reasonable price. 10 pieces - For M6 screws!

Available

€8.49 *

Sheet metal nuts/ screw set M5x12, 10pcs., gold-coloured

Here we can offer you 10 sheet metal nuts incl. the suitable lens head cross recessed screws. The screws and lenses are especially suitable for fixing the fairing. The brass-coloured screws also give your moped a noble gold screw look....

Available

€5.19 *

Hose clamp, large, d=32mm, stainless

Hose clamps can be used in almost any application. Whether as reinforcement of the rubber mountings of the exhaust, or as a normal water hose clamp.

Available

€1.29 *

Adapter screw Mirror, different models

Motorcycle mirrors as well as the manufacturer's built-in mount on the handlebars are unfortunately not always the same. So it is sometimes necessary to get suitable adapters for the mirror to be able to screw the mirror onto the moped....

Available

From €2.50 *

NEW

Hexagon socket screw Aprilia OEM, m6x20

This article is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : 667152 Scope of delivery: 1

Out of Stock

€1.29 *

NEW

Bolt Aprilia OEM, tcei m6x13

This article is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : AP4ABN000117 Scope of delivery: 1

Available

€14.99 *

NEW

Cylinder head bolt Aprilia OEM, m8x166

This article is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : AP3ADN000115 Scope of delivery: 1

Almost gone

€11.99 *

NEW

Ball bearing Nachi, 6202/NSE9

Quality bearings from Nachi Increased service life of wheel bearings! Outer diameter: 35 mm Width: 11 mm Inner diameter: 15 mm Waterproof

Almost gone

€7.99 *

Throttle cable intermediate tensioner, universell

This intermediate tensioner is a practical accessory for adjustments or simply to adjust the tension of a Bowden cable. With a spring travel of 18 mm, it enables precise adjustment of the cable tension.

Available

€1.50 *

Schraube Aprilia OEM, Aprilia M545 Motoren (RS4 / RS / RX / SX 125 4T), z. befestigung des Stators, M5x16

Bei diesem Artikel handelt es sich um ein Originalersatzteil (OEM) der Firma Aprilia Lieferumfang: 1 Stück OEM Artikelnummer zu Vergleichszwecken : 1A003109 Lieferumfang: 1

Available

€2.69 *