1. Choose model
RX/SX 125 (ab 2021, KT - Euro5)
SX 125 (2018 bis 2020, KXB - Euro4)
SX 125 (2008 bis 2014)
2. Filter by category
No results were found for the filter!
Complete revision kit for Rotax 122 & 123 125cc engine. The set consists of all necessary gearbox & crankshaft bearings, as well as the appropriate sealing rings. If larger repairs and a splitting of the engine are planned, it is always...
Available
€53.90
*
Available
€2.99
*
Simple exhaust spring, to hang the exhaust system on the cylinder, or to connect the muffler & manifold. Can also be used for other tinkering. The spring has ring eyelets at both ends. A little trickier to fit, but the hold is better!...
Available
€2.59
*
Typical brake disks, or sprocket bolt with blue dry thread lock (medium strength). Can also be used anywhere else on the moped. Thread: M6 Head: Flat / Torx Length: 20 mm
Available
€1.99
*
During maintenance work on the brake system, these small parts are often lost. The bleeder nipple can then become clogged and maintenance of the brake system becomes impossible the next time. A cover should therefore always be installed!
Available
€2.99
*
Wheel bearing which can be used for different vehicles as front or rear wheel bearing. Note Please compare the technical data of this bearing with your original wheel bearing. Technical data Outside diameter: 32 mm width: 10 mm Inner...
Available
€5.99
*
Universal SKF bearing of type "6202-2RS", sealed on both sides. Suitable for example as rear or front axle bearing. But please compare your bearing type before ordering! Technical data Type : 6202 Inner diameter : 15 mm Outside diameter...
Available
€6.29
*
Magnetic oil drain plugs collect the metallic abrasion at the magnet and thus protect the engine & gearbox from excessive wear. Supplied with sealing ring.
Available
€5.99
*
Nut with M7 thread for fixing the cylinder head. A set of 4 special nuts is supplied. The nuts have a length of 13mm and have a collar. Special thread M7. Suitable for all Minarelli, Kymco, MBK, Yamaha, CPI, Keeway engines and other...
Available
€3.99
*
6mm clamp for fuel hoses. Delivered is 1 piece.
Available
€1.99
*
We can supply these spare clips for your fairing at a reasonable price. 10 pieces - For M6 screws!
Available
€8.49
*
Here we can offer you 10 sheet metal nuts incl. the suitable lens head cross recessed screws. The screws and lenses are especially suitable for fixing the fairing. The brass-coloured screws also give your moped a noble gold screw look....
Available
€5.19
*
Hose clamps can be used in almost any application. Whether as reinforcement of the rubber mountings of the exhaust, or as a normal water hose clamp.
Available
€1.29
*
Motorcycle mirrors as well as the manufacturer's built-in mount on the handlebars are unfortunately not always the same. So it is sometimes necessary to get suitable adapters for the mirror to be able to screw the mirror onto the moped....
Available
From €2.50
*
NEW
This article is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : 667152 Scope of delivery: 1
Out of Stock
€1.29
*
NEW
This item is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : AP0240820 Scope of delivery: 1
Out of Stock
€14.99
*
NEW
This article is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : AP4ABN000117 Scope of delivery: 1
Available
€14.99
*
NEW
This article is an original spare part (OEM) from Aprilia OEM part number for comparison purposes : AP3ADN000115 Scope of delivery: 1
Available
€11.99
*
NEW
Ball bearing Nachi, 6202/NSE9
Quality bearings from Nachi Increased service life of wheel bearings! Outer diameter: 35 mm Width: 11 mm Inner diameter: 15 mm Waterproof
Out of Stock
€7.99
*
NEW
Throttle cable intermediate tensioner, universell
This intermediate tensioner is a practical accessory for adjustments or simply to adjust the tension of a Bowden cable. With a spring travel of 18 mm, it enables precise adjustment of the cable tension.
Available
€1.50
*
Bei diesem Artikel handelt es sich um ein Originalersatzteil (OEM) der Firma Aprilia Lieferumfang: 1 Stück OEM Artikelnummer zu Vergleichszwecken : 1A003109 Lieferumfang: 1
Available
€2.69
*
This article is an original spare part from Aprilia OEM part number for comparison purposes : 2R000049 Scope of delivery: 1
Available
€2.99
*
Entlüftungsschraube für den hinteren Bremssattel. Aprilia Origianlersatzteil. OEM Artikelnummer zu Vergleichszwecken Aprilia / Piaggio: 890306 Lieferumfang: 1 Stück.
Available
€10.99
*
Lieferumfang 1 Stück. Aprilia Originalersatzteil. Maß: M8x20 Schlüssel: Torx® OEM Artikelnummer zu Vergleichszwecken Aprilia: 2B004309
Available
€2.69
*
Viewed