1. Choose model
GPR 125 2T (2005 bis 2009)
GPR 125 4T (2009 bis 2016, RG1)
2. Filter by category
No results were found for the filter!
If your engine does not warm up properly in winter, it is usually due to a defective coolant thermostat. This small part is unfortunately often forgotten and poorly maintained on motorcycles, as it cannot influence the heating as it does...
Available
€25.95
*
This item is an original spare part (OEM) of the brand Piaggio (Aprilia). OEM part number for comparison purposes Piaggio: 871418 Scope of delivery: 1 pc.
Available
€4.99
*
The basis for an optimally functioning engine and good maintenance of your vehicle is a tight engine. An oil leak is not only bad for the environment, but can also lead to dicey situations in fast cornering. So if you discover a leak...
Available
€20.90
*
Arrow replacement seal. Can be used not only with Arrow, but also with all other exhaust systems with 32mm diameter and plug-in flange. Technical data Diameter (inside): 32mm width: 30mm
Available
€10.00
*
Clamps / hose clamps, 50 parts
Practical assortment box with different sizes of hose clamps. Should not be missing in any well-assorted workshop. Delivered are 10 clamps each in 6, 8, 10, 12 and 14mm diameter.
Almost gone
€34.95
*
choke lever, Universal, various colors, for mounting on handlebars
Universal choke lever for custom conversions. Simple mounting with clamp, directly on the handlebars as mentioned, fits virtually any cable choke. Available in black & chrome.
Available
€10.99
*
Oil contamination on the underbody or on the engine is due to a defective seal. In many cases the valve cover gasket is the cause. When servicing the valve train, it is often not replaced. In general, seals should always be replaced to...
Available
€53.95
*
Carburettor DellOrto PHBH 28 BS, universal
The PHBH 28mm version can be used as a replacement carburettor on various 125cc vehicles (e.g. RS 125). On 125s with a smaller carburettor, it can even have a slight performance-enhancing effect if tuned correctly. Note Does NOT have an...
Available
€139.90
*
Hose clamp, universal, 8 x 300mm
Practical set for assembling hose clamps yourself. Consisting of 8 screw clips and a 30cm long steel band. The band can be torn off in the desired length, then only the clip is attached and the clamp is ready for use. Notes Cut the tape...
Available
€5.99
*
Copper seal ring. Technical data Inner diameter: 31.50 mm Outside diameter: 40.00 mm thickness: 4 .00 mm
Available
€5.95
*
Replacement graphite manifold gasket. Fits in principle all vehicles with straight flange or plug-in flange connections up to 42mm diameter. (42mm is for example the original size of the Yamaha YI-3 & YI-4 engine).
Available
€4.99
*
Aluminium/steel manifold gasket from Athena. Can be used on all vehicles with the corresponding outlet dimension of 45mm diameter.
Available
€4.50
*
Fuel tap, universal, M16 x 1,5
Largely universal, vacuum-controlled petrol tap with screw connection. The scope of delivery also includes the pre-filter (tube), which sits in the petrol tap. Suitable for all petrol tanks with corresponding thread & vacuum connection....
Available
€10.99
*
The timing chain tensioner is an important component. In the event of a defect, it can even lead to engine damage. Due to the pressure that the tensioner puts on the timing chain, it is always optimally tensioned. If this is not the...
Out of Stock
€20.95
*
Paper seal to seal the timing chain housing. Should be replaced during all maintenance work on the timing chain tensioner. OEM part number for comparison purposes 430350; 834254; 862777; AP8550429; AP8575011; 847928
Available
€3.19
*
A rattling noise from the engine can often be explained by a worn timing chain. Poor oil or few oil changes will damage the timing chain. In addition, a defective timing chain tensioner can lead to problems with the chain. In order to...
Out of Stock
€99.90
*
;
€69.95
*
Graphite sealing ring from Athena. Can be used in many different vehicles as a seal for overlapping plug connections.
Available
€13.95
*
Hose clamp assortment, 50 parts
Galvanized steel hose clamps with worm thread for attaching hoses to pipes and hose nozzles. Including 8mm socket wrench. Sizes: 12 x 13-19mm 12 x 16-22mm 10 x 18-27mm 7 x 20-32mm 5 x 22-38mm 3 x 24-44mm
Available
€27.95
*
18mm hose clamp from Piaggio, can of course be used on all vehicles. OEM part number for comparison purposes 879888; 256074; 577557; AP8104072
Available
€4.99
*
Available
€1.99
*
Spare gasket for the ignition cover.
Available
€4.99
*
Available
€1.49
*
Viewed