Tip Use our  Bike-Filter to get only suitable articles displayed.
0 Article
 

KSR Moto GRS 125 Screws, nuts & small parts

1. Choose model
GRS 125 (2014 bis 2019)
Close filters
1 From 5
No results were found for the filter!
Clutch cable adjusting screw
Clutch cable adjusting screw, M8, universal
Dimensions: Thread: M8 Inner diameter: 8.5 mm

Available

€2.99 *
Exhaust spring
Exhaust spring, universal, 44mm
Simple exhaust spring, to hang the exhaust system on the cylinder, or to connect the muffler & manifold. Can also be used for other tinkering. The spring has ring eyelets at both ends. A little trickier to fit, but the hold is better!...

Available

€2.59 *
Screw
Screw, M6 x 20 mm, flat head / inner corner (Torx), stepped
Typical brake disks, or sprocket bolt with blue dry thread lock (medium strength). Can also be used anywhere else on the moped. Thread: M6 Head: Flat / Torx Length: 20 mm

Available

€1.99 *
Cover cap brake bleeding nipple
Cover cap brake bleeding nipple, different colours, pack of 2
During maintenance work on the brake system, these small parts are often lost. The bleeder nipple can then become clogged and maintenance of the brake system becomes impossible the next time. A cover should therefore always be installed!

Available

€2.99 *
Wheel bearing
Wheel bearing, different vehicles, type: 62012RS
Wheel bearing which can be used for different vehicles as front or rear wheel bearing. Note Please compare the technical data of this bearing with your original wheel bearing. Technical data Outside diameter: 32 mm width: 10 mm Inner...

Available

€5.99 *
Ball bearing 6202 2RS
Ball bearing 6202 2RS, universal
Universal SKF bearing of type "6202-2RS", sealed on both sides. Suitable for example as rear or front axle bearing. But please compare your bearing type before ordering! Technical data Type : 6202 Inner diameter : 15 mm Outside diameter...

Available

€6.29 *
Oil drain plug
Oil drain plug, universal, M12x1.5, magnetisch
Magnetic oil drain plugs collect the metallic abrasion at the magnet and thus protect the engine & gearbox from excessive wear. Supplied with sealing ring.

Available

€5.99 *
Cylinder head nut
Cylinder head nut, Set of 4 - M7
Nut with M7 thread for fixing the cylinder head. A set of 4 special nuts is supplied. The nuts have a length of 13mm and have a collar. Special thread M7. Suitable for all Minarelli, Kymco, MBK, Yamaha, CPI, Keeway engines and other...

Available

€3.99 *
Clamp
Clamp, universal, for example f. petrol, water or oil hoses, 6mm
6mm clamp for fuel hoses. Delivered is 1 piece.

Available

€1.99 *
Retaining clamps set
Retaining clamps set, e.g. for cladding
We can supply these spare clips for your fairing at a reasonable price. 10 pieces - For M6 screws!

Available

€8.49 *
Sheet metal nuts/ screw set M5x12
Sheet metal nuts/ screw set M5x12, 10pcs., gold-coloured
Here we can offer you 10 sheet metal nuts incl. the suitable lens head cross recessed screws. The screws and lenses are especially suitable for fixing the fairing. The brass-coloured screws also give your moped a noble gold screw look....

Available

€5.19 *
Hose clamp
Hose clamp, large, d=32mm, stainless
Hose clamps can be used in almost any application. Whether as reinforcement of the rubber mountings of the exhaust, or as a normal water hose clamp.

Available

€1.29 *
Adapter screw Mirror
Adapter screw Mirror, different models
Motorcycle mirrors as well as the manufacturer's built-in mount on the handlebars are unfortunately not always the same. So it is sometimes necessary to get suitable adapters for the mirror to be able to screw the mirror onto the moped....

Available

From €2.50 *
NEW
Ball bearing Nachi Ball bearing Nachi, 6202/NSE9
Quality bearings from Nachi Increased service life of wheel bearings! Outer diameter: 35 mm Width: 11 mm Inner diameter: 15 mm Waterproof

Out of Stock

€7.99 *
NEW
Throttle cable intermediate tensioner Throttle cable intermediate tensioner, universell
This intermediate tensioner is a practical accessory for adjustments or simply to adjust the tension of a Bowden cable. With a spring travel of 18 mm, it enables precise adjustment of the cable tension.

Available

€1.50 *
Ball bearing / wheel bearing Ball bearing / wheel bearing, Type: 6005 2RS
Single ball bearing / wheel bearing for various vehicles. Please compare the bearing sizes with the standard bearings of your bike before ordering. Technical data Inner diameter: 25mm Outer diameter: 47mm Width: 12mm Sealed on both sides

Available

€2.99 *
Mounting bracket Schmitt Mounting bracket Schmitt, universell
Universal with rubber buffer, e.g. for radiators, tanks, custom panels etc...

Available

€9.99 *
Blechmutter Piaggio/Aprilia OEM
Blechmutter Piaggio/Aprilia OEM, M5 universal
Standard M5 Blechmutter zur Befestigung der meisten gängigen Verkleidungsschrauben.

Available

€1.99 *
Locking bolt cylinder head Most Racing Locking bolt cylinder head Most Racing, M14x1,5, versch. Colors
This high quality aluminum sealing bolt with thread size M14x1.5 and matching copper sealing ring is an indispensable accessory for anyone looking for a reliable and durable sealing bolt. With its versatility, this bolt is perfect for...

Available

€17.95 *
Locking bolt cylinder head Most Racing Locking bolt cylinder head Most Racing, M12x1,5, versch. Colors
The aluminum locking bolts with thread size M12x1.5 and matching copper sealing ring are the perfect solution for closing holes, such as the temperature sensor hole on Derbi Euro4 models. Of course, the bolt is also suitable for other...

Available

€17.95 *
Shaft circlip Yamaha OEM
Shaft circlip Yamaha OEM, universell
This item is an original spare part (OEM) of the brand Yamaha/Minarelli. The clip is used in various places for various bikes. An example on Yamaha motorcycles is the water pump. OEM part number for comparison purposes 990091040000,...

Available

€1.99 *
Hollow head screw Hollow head screw, Magnetic, black, various Versions
Dimensions: M8X1.25 -20mm M8X1.25 -25mm M8X1.25 -35mm M10X1.25 -16mm M10X1.5 -15mm M10X1.5 -22mm M12X1.25 -10mm M12X1.5 -15mm M12X1.5 -12mm M8X1.5 -16mm M8X1.25 -15mm Scope of delivery: incl. copper gasket

Available

€11.99 *
Needle roller bearing / Gearbox bearing / Shift drum bearing / Shaft bearing Needle roller bearing / Gearbox bearing / Shift drum bearing / Shaft bearing, universal, 10x10x14
This article is a cheap alternative to the expensive original spare part. The bearing corresponds to the original in shape, dimensions and connections. It can be used in different places of different bikes. OEM part number for comparison...

Available

€2.99 *
Gearbox bearing / Needle roller bearing / Shift shaft bearing Gearbox bearing / Needle roller bearing / Shift shaft bearing, universell, 12x16x10
This item is a cheap alternative to the expensive original spare part. The bearing corresponds to the original in shape, dimensions and connections. It can be used in different places of different bikes. OEM part number for comparison...

Available

€2.99 *
1 From 5
Viewed