1. Choose model
RC 125 (2017 bis 2020, Euro4)
RC 125 (2014 bis 2016, Euro3)
2. Filter by category
No results were found for the filter!
The coolant thermostat is an important part of the cooling system. If it no longer opens or closes correctly, the engine can overheat or undercool while driving. In the worst case, this can lead to engine damage. Therefore, you should...
Available
€31.95
*
Bei diesem Artikel handelt es sich um ein Original Ersatzteil (OEM) der Marke KTM OEM Artikelnummer zu Vergleichszwecken 93530027000 Lieferumfang: 1 Stck.
Out of Stock
€12.99
*
This article is an original spare part (OEM) of the manufacturer of the brand KTM.
Available
€2.19
*
This item is an original spare part (OEM) of the brand KTM. OEM part numbers for comparison purposes - KTM 90136003003 Scope of delivery: 1 pc.
Available
€2.99
*
This article is an original spare part (OEM) of the manufacturer of the brand KTM.
Almost gone
€2.99
*
Arrow replacement seal. Can be used not only with Arrow, but also with all other exhaust systems with 32mm diameter and plug-in flange. Technical data Diameter (inside): 32mm width: 30mm
Available
€10.00
*
Clamps / hose clamps, 50 parts
Practical assortment box with different sizes of hose clamps. Should not be missing in any well-assorted workshop. Delivered are 10 clamps each in 6, 8, 10, 12 and 14mm diameter.
Available
€34.95
*
Reinforced clutch springs increase the contact pressure on the clutch linings and thus prevent the clutch from slipping. Especially after tuning work. Reinforced clutch springs can be used as a spare part for lighter tuning stages but...
Out of Stock
€14.99
*
Reinforced clutch springs from EBC, 10% harder than the original springs. Provides relief for slipping clutches by increasing performance.
Almost gone
€15.50
*
Hose clamp, universal, 8 x 300mm
Practical set for assembling hose clamps yourself. Consisting of 8 screw clips and a 30cm long steel band. The band can be torn off in the desired length, then only the clip is attached and the clamp is ready for use. Notes Cut the tape...
Available
€5.99
*
Replacement seal from Athena. In case of oil leaks or adjustment work on the open cylinder head, gaskets should be replaced as a precaution.
Almost gone
€22.95
*
Replacement rubber from Athena. In case of oil leaks, or adjustment work on the open cylinder head gaskets should be replaced as a precaution. This rubber seals screw holes. Delivery 1 piece.
Almost gone
€3.99
*
Copper seal ring. Technical data Inner diameter: 31.50 mm Outside diameter: 40.00 mm thickness: 4 .00 mm
Available
€5.95
*
Replacement graphite manifold gasket. Fits in principle all vehicles with straight flange or plug-in flange connections up to 42mm diameter. (42mm is for example the original size of the Yamaha YI-3 & YI-4 engine).
Available
€4.99
*
Aluminium/steel manifold gasket from Athena. Can be used on all vehicles with the corresponding outlet dimension of 45mm diameter.
Available
€4.50
*
Maintenance work on the engine is always a good opportunity to replace the seals at the same time. If maintenance work is necessary on the alternator side of the engine, we recommend to install a new gasket, if the cover is already removed.
Available
€8.99
*
If the coupling is replaced or other maintenance work is pending under the coupling cover, it is always advisable to invest in a new seal at the same time. Subsequent oil leaks are always annoying and can thus be avoided.
Available
€7.99
*
Complete engine gasket set from Athena, suitable for KTM 125cc 200cc and 390cc 4-T engines. The gasket set includes cylinder base, head & valve cover gaskets as well as the gaskets for clutch & alternator covers and many other small...
Available
€74.95
*
Benzinhahn, universal, M16 x 1,5
Largely universal, vacuum-controlled petrol tap with screw connection. The scope of delivery also includes the pre-filter (tube), which sits in the petrol tap. Suitable for all petrol tanks with corresponding thread & vacuum connection....
Available
€10.99
*
Graphite sealing ring from Athena. Can be used in many different vehicles as a seal for overlapping plug connections.
Out of Stock
€13.95
*
Hose clamp assortment, 50 parts
Galvanized steel hose clamps with worm thread for attaching hoses to pipes and hose nozzles. Including 8mm socket wrench. Sizes: 12 x 13-19mm 12 x 16-22mm 10 x 18-27mm 7 x 20-32mm 5 x 22-38mm 3 x 24-44mm
Available
€27.95
*
18mm hose clamp from Piaggio, can of course be used on all vehicles. OEM part number for comparison purposes 879888; 256074; 577557; AP8104072
Available
€4.99
*
Available
€1.99
*
Available
€1.49
*
Viewed