Tip Use our  Bike-Filter to get only suitable articles displayed.
0 Article
 

Fork & Shock absorber

Close filters
4 From 5
No results were found for the filter!
Fork seal Kawasaki OEM
Fork seal Kawasaki OEM, Kawasaki Z 125 from year 18, Ninja 125 from year 19, fork sealing ring
This item is an original spare part (OEM) of the brand Kawasaki. OEM part number for comparison purposes 920490740 Scope of delivery: 1 piece!

Available

€18.78 *
Fork seal & dust cap set Honda OEM
Fork seal & dust cap set Honda OEM, Honda CB 125 R from year 18
This set, consisting of a dust cap and a fork seal ring is an original spare part (OEM) from Honda. For the professional repair of the fork are of course 2 stck. Needed. OEM part number for comparison 51490MKAD81, 51490MERR61

Almost gone

€32.62 *
Fork seal rings Athena
Fork seal rings Athena, Aprilia RS4 125 from year 06-18, 40 x 52 x 10mm
Spongy riding behaviour or obvious oil loss at the fork are signs that it is time for a fork service. Athena sealing rings are of higher quality than OEM seals, or are even used as OEM seals by fork manufacturers. Athena sealing rings...

Available

€10.99 *
Fork seal rings Athena
Fork seal rings Athena, 31 x 43 x 10,3mm
Athena, as one of the leading manufacturers of sealants, has the largest selection of Simmerring and dust cap sets in the world. These gaskets are used by some manufacturers as original equipment, or are of higher quality than the OEM...

Available

€9.99 *
Sealing ring Honda OEM
Sealing ring Honda OEM, Honda CBF/CBR 125 (JC34A, JC39A, JC40A, JC50A, JC50B)
Upper dust protection sealing ring for the steering head bearing. OEM part number for comparison purposes: 53214-200-000; 53214200000

Almost gone

€5.95 *
Lowering kit
Lowering kit, Yamaha YZF-R / MT 125 year 14-18 (RE11, RE29), with ABE
With these levers the rear of the Yamaha MT, or YZF-R 125 can be lowered a few centimeters. This makes it easier for smaller riders to get on and off the bike. However, due to the installation of the lowering system, it is often not...

Almost gone

€124.95 *
Rate of increase TRW
Rate of increase TRW, Kawasaki Z 125
This elevation kit offers larger riders an easy way to adopt a more comfortable seating position. But also normal sized riders can benefit from a heightening kit. As the rear end is raised, the geometry of the chassis changes. Many...

Almost gone

€102.90 * ; €61.95 *
Forked seal ring set Athena
Forked seal ring set Athena, Yamaha WR 125, MT-07 (RM04), MT-09 (RN29)
Simmerring set Athena, these are of higher quality than the OEM seals and guarantee a remarkable performance and resistance to high temperatures and abrasion. outer rubber, double sealing lip Suitable for Showa forks with 41mm...

Available

€16.99 *
Shock absorber Mono YSS
Shock absorber Mono YSS, Aprilia RS 125 until 2005
Aprilia RS125 2-stroke models have, apart from the often criticized Lifetime the cylinder / piston Combination another great Problem which concerns the original Sachs rear shock absorber. Especially with increasing age this shock...

Available

€219.00 *
Dust caps fork JMP
Dust caps fork JMP, Beta RR 125 year 14-, KTM SX / EXC 125 / Duke 690 from year 08
Dust caps protect the fork seals from dust and coarse dirt, which extends the service life of the fork seals accordingly. Technical data 48x58.5x6/11.5

Almost gone

€31.50 *
Dust caps fork Dust caps fork, Yamaha WR 125, MT07 (RM04), 41x53.5x12mm
Dust caps protect the fork seals from dust and coarse dirt, which extends the service life of the fork seals accordingly.

Available

€24.90 *
dust caps fork Athena
dust caps fork Athena, KTM Duke / RC 125 up to model year 16, 43x53.4x5.8/13 mm
Dust caps, as the name suggests, protect the fork seal rings from dust and coarse dirt. In this way they ensure that forked shaft seals last as long as possible. If the Simmerrings are defective and leaky, the dust protection should be...

Available

€10.59 *
Steering head bearing set Steering head bearing set, Yamaha MT, YZF-R 125 up to year 2018
The steering head bearing is thoroughly checked during the technical inspection of the vehicle. If it is worn out or slightly jammed, the motorcycle will not get a new sticker. The only remedy is to replace the bearing.

Out of Stock

€50.95 *
Fork seal rings Athena
Fork seal rings Athena, KTM Duke / RC 125 up to model year 16, 43x52.9x9/11,4mm
Quality radial shaft seals from Athena, suitable for KTM Duke 125, 200 and 390 models, as well as KTM RC 125, 200 & 390 up to model year 2017. One set is delivered. Dimensions: 43x52.9x9/11.4 mm

Available

€15.99 *
Lowering kit TRW
Lowering kit TRW, KTM Duke 125 year 11-16, KTM RC 125 year 14-16, with ABE
With the TRW-Lucas rear lowering there is a cost-effective way to reduce the seat height. On most models this is achieved by changing the linkage of the shock absorber. The installation in a specialist workshop is recommendable,...

Out of Stock

€179.94 * ; €114.90 *
Steering head bearing set JMP
Steering head bearing set JMP, Honda CBR 125 from year 05 (JC34, 39, 50), CBF 125 year 09-16 (JC40), NSR 125 year...
The steering head bearing is carefully checked during the technical inspection of the vehicle. If it is worn out or slightly jammed, the motorcycle will not get a new sticker. The only remedy is to replace the bearing.

Almost gone

€39.95 *
Steering head bearing set Steering head bearing set, Yamaha YBR 125
The steering head bearing is thoroughly checked during the technical inspection of the vehicle. If it is worn out or slightly jammed, the motorcycle will not get a new sticker. The only remedy is to replace the bearing.

Available

€13.99 *
Suspension strut Yamaha
Suspension strut Yamaha, YZF-R/MT 125, from year 14
A worn rear leg can be noticed quite quickly, even if the rear swings when tilting in curves. In addition, a leak at the upper oil ring is often visible, which spreads oil over a large area on the swingarm and possibly even on the rear...

Out of Stock

€288.90 * ; €139.90 *
Steering head bearing Piaggio OEM
Steering head bearing Piaggio OEM, Aprilia SX 125 from year 18
Aprilia or Piaggio original spare part, bearing designation SKF: 6205 25x52x15 OEM part number for comparison purposes 00000056205

Available

€9.99 *
Fork guard / shock absorber protection Acerbis
Fork guard / shock absorber protection Acerbis, universal, neoprene, 40-50mm, black
These fork protectors or shock protectors are made of flexible, waterproof black neoprene with Acerbis logo. The universal tube protectors are suitable for off-road use or just for the off-road look. At 40-50mm diameter they are easy to...

Available

€27.95 *
Fork-type bellows Polisport
Fork-type bellows Polisport, universal, different colours
Protects the fork from stone chips, dirt and moisture. Available in 3 colours. Technical data length: 350mm width top: 32mm width bottom: 58mm 28 shafts

Almost gone

€16.99 *
NEW
Gabelbrücke (Oben) Rieju OEM
Gabelbrücke (Oben) Rieju OEM, Rieju Marathon (MRT) Bj. 09-17, USD
Bei diesem Artikel handelt es sich um ein Originalersatzteil der Marke Rieju. Die Gabelbrücke passt nur für Rieju MRT- Pro USD Gabel! OEM-Nummer zu Vergleichszwecken: 0/000.660.4002

Almost gone

€239.90 *
NEW
Fork seal set SKF HD Fork seal set SKF HD, Beta RR 2T 125/200/300/400 ab Bj 20
When developing the fork seals, SKF focused on maximum sealing performance and therefore uses the highest quality materials for fork seals and dirt wipers. The sealing kits from SKF offer a particularly low "stick-slip" effect - in other...

Almost gone

€35.95 *
NEW
Fork seal set SKF Fork seal set SKF, Beta RR 2T 125/200/300/400 ab Bj 20
When developing the fork seals, SKF focused on maximum sealing performance and uses the highest quality materials for fork seals and dirt wipers. The sealing kits from SKF offer a particularly low "stick-slip" effect - in other words,...

Almost gone

€34.95 *
4 From 5

Gabel und Stossdämpfer sind wichtige Komponenten jedes 125ccm Motorrads. Sie tragen dazu bei, die Fahrsicherheit zu erhöhen und das Fahrgefühl zu verbessern. In unserem Shop bieten wir original Ersatzteile, Dichtungen und Tieferlegungen für Gabel und Stossdämpfer von 125er Motorrädern an.

Unsere hochwertigen Ersatzteile sorgen dafür, dass dein Motorrad immer in Top-Zustand bleibt und du sicher unterwegs bist. Auch wenn du dein Bike optisch aufwerten möchtest, bieten wir Tieferlegungen an, die nicht nur cool aussehen, sondern auch das Handling verbessern.

Besuche unseren Shop und entdecke unsere große Auswahl an Gabel- und Stossdämpfer

Wer ein 125er Motorrad fährt, weiß wie wichtig eine gute Gabel und ein zuverlässiger Stossdämpfer sind. Sie sorgen nicht nur für mehr Fahrkomfort, sondern auch für mehr Sicherheit und Stabilität bei jeder Fahrt. Deshalb bieten wir in unserem Shop eine große Auswahl an Gabeln und Stossdämpfern für 125er Motorräder von renommierten Marken wie Yamaha, Honda und Suzuki.

Aber wir wissen auch, dass junge Motorradfahrer oft auf der Suche nach individuellen, einzigartigen Teilen sind, um ihr Bike aufzuwerten und es von der Masse abzuheben. Deshalb haben wir auch eine Reihe von speziellen Gabeln und Stossdämpfern im Angebot, die nicht nur leistungsstark sind, sondern auch ein cooles Design haben.

Überzeuge dich selbst von der Qualität unserer Gabeln und Stossdämpfer und schau in unserem Shop vorbei. Wir sind sicher, dass du das perfekte Teil für dein 125er Motorrad finden wirst.

Viewed