2. Filter by category
No results were found for the filter!
From Italkit we can offer here a supplement to the 125cc original Rotax cylinder, as well as the 140cc tuning cylinder kit. The combustion chamber calotte clearly increases the compression of the cylinder and is optimized in its geometry...
Available
€89.95
*
From Italkit we can offer here a supplement to the 125cc original Rotax cylinder, as well as the 140cc tuning cylinder kit. The combustion chamber calotte clearly increases the compression of the cylinder and is optimized in its geometry...
Available
€89.95
*
NGK Iridum spark plug type LKAR8AI-9 This spark plug fits exclusively on vehicles with KTM engine, because a specific plug connector is used (KTM: VS05EGAK). Technical data Width across flats: 14mm Thread diameter: 12.0 mm thread length:...
Available
€25.90
*
NGK standard spark plug type CR9E. Technical data Width across flats:16 mm Thread diameter:10,0 mm Thread length:19.0 mm Electrode distance:0.8 mm Resistance: interference suppressed, 5 KOhm Notes Standard spark plug of the Yamaha YI-3...
Available
€11.99
*
Poorly maintained or not maintained at all fuel filters are often a reason why the vehicle suddenly won't start anymore in vehicles with high mileage. In general, the filter should be replaced according to the prescribed interval.
Available
€20.95
*
This wiring harness is needed to connect the Polini ECU device to Yamaha injectors.
Out of Stock
€24.95
*
Reinforced clutch springs from EBC, 10% harder than the original springs. Shank remedy for slipping clutches by increasing performance.
Almost gone
€15.50
*
Small component with great effect. The valve stem seal influences for example the oil consumption. Hard "stems" let oil run down the valve, which is then burned. Whenever work is carried out on the dismantled cylinder head, it is...
Available
€3.99
*
To get the absolute maximum power out of Yamaha's YI-3 engines, this 62mm Ø Naraku cylinder head is indispensable. More passage, reinforced valve springs and larger valves (21/23mm) let every cylinder with 62-64mm bore breathe properly....
Almost gone
€429.90
*
The Malossi Force Master II system primarily manipulates the injection times, which are passed on from the original control unit to the injection nozzle. This system is included in the 180cc cylinder kit. With three different...
Out of Stock
€285.00
*
Controller / rectifier, Yamaha YZF-R 125
The rectifier or regulator changes the AC voltage generated in the alternator to the DC voltage of 12V used in the vehicle electrical system and keeps the voltage within a certain tolerance range. This charges the battery and ensures...
Almost gone
€45.00
*
Valve stem seals, KTM Duke/RC 125, 4 pcs.
Valve stem seals are installed to prevent oil from the cylinder head from entering the combustion chamber via the valve guides. A blue smoking exhaust can be an indication for defective valve stem seals. Scope of delivery 4 pcs: 2x...
Almost gone
€15.99
*
To ensure that the clutch discs can withstand the high stresses and temperatures of racing, these pads are made of carbon fibre. Wear and fading are reduced to a minimum and even under extreme loads the material prevents the pads from...
Out of Stock
€60.95
*
This Athena tuning cylinder kit differs technically only slightly from the cylinder kit that was specially developed for the Yamah a WR 125. The most significant difference between this and the other Athena kit is the mapping of the ECU,...
Available
€439.95
*
In addition to the 125cc standard cylinder kit, Airsal also offers a T6 racing version. The main difference of the T6 compared to the 125cc standard cylinder is the improved piston, which significantly changes the combustion chamber...
Available
€145.95
*
Cork-based product, impregnated with aluminium particles to increase durability and heat resistance. The material is highly compacted to avoid swelling. The CK series clutch kits contain a complete set of friction linings and are...
Available
€37.95
*
Features Increased compression force of 10 to 15% compared to standard springs Reduction of clutch slippage Made of heat-treated carbon steel
Available
€13.99
*
Replacement gaskets for the 180cc 4-stroke cylinder from Top Performances.
Available
€22.95
*
With the Athena GET Chiptuning, the original performance of the KTM Duke can be increased by a few extra horsepower, depending on which setup is used. The GET unit is simply exchanged for the original CDI control unit. Afterwards the...
Almost gone
€329.95
*
You need a new oil seal kit for tuning your KTM Duke 125cc engine? We offer you the complete set from the manufacturer Athena, consisting of the matching five rings. Athena supplies the seal set exclusively in the best original equipment...
Available
€17.99
*
Replacement piston from Italkit for the 140cc Rotax cylinder. Scope of delivery Piston ring(s) Piston pin Piston pin clips
Available
€124.90
*
Available
€22.95
*
The Airsal YI-3 cylinder for the Yamaha 125cc engines is supposed to be a cheap alternative to the expensive original cylinder. Airsal not only uses a copy of the original cylinder, but also improves the coating, the piston and the...
Available
€139.90
*
Spare rings for the Yamaha YI-3 OHC engine. (Yamaha YZF R125, WR 125, etc..)
Available
€17.99
*
Viewed